Factory Zinc Aluminum Alloy Steel Wire 1.0mm

We have achieved rapid development in recent years, established a scientific and technological service team full of innovation ability to continuously promote the upgrading of Valve cold-drawn alloy spring wire factory, Square spring steel wire EN10270-2, Alloy spring steel wire for valves and application technologies. You should find our web page to check additional info from our products. Hope we can be your trustworthy supplier in China.

Characteristics and scope of application:

Is widely used in Si Mn spring steel, strength, elasticity and hardenability, slightly higher than 55Si2Mn. Suitable for railway vehicles, automobile and tractor industry production bear a larger load or a flat spring wire diameter in the spiral spring, below 30mm is suitable for the production of temperature at 250 DEG C nonrefractory spring corrosion medium and under alternating load and in large type under high stress the importance of working roll spring.

Chemical composition:

C:0.56 to 0.64

Si:1.60 to 2

Mn:0.60 to 0.90

S: = 0.030

P: = 0.030

Cr: = 0.35

Ni: = 0.35

Cu: = 0.25

Mechanical properties:

The ultimate tensile strength of B (MPa): 1568 (160)

Yield strength s (MPa): 1372 (140)

10 elongation (%): 5

Section shrinkage (%): 20 PSI

The hardness is less than or equal to 321HB;: hot rolling, cold drawing + heat treatment, less than 321HB

Specification and metallographic structure of heat treatment:

Specification for heat treatment: quenching at 870 + 20 C, oil cooling; tempering at 440 C + 50 C (special needs, + 30).

We will make every effort to be outstanding and perfect, and accelerate our steps for standing in the rank of international top-grade and high-tech enterprises for Factory Zinc Aluminum Alloy Steel Wire 1.0mm. We always adhere to the professional, dedicated and dedicated service concept. We are going to work wholeheartedly to improve our products and services.